Arch Sewing — Pegasus Sewing Machines

W600 Series – Labor Saving Devices

back to main Pegasus page

W600 Series

Application table and features of UT

Pegasus offers a wide variety of labor saving devices to maximize productivity and quality.
You can choose the most suitable device to meet your demands now.

UT – Thread trimmer (pneumatic type / electric type)
Cuts the threads easily. All the operator has to do is press the treadle with heel. Eliminates the need for cutting the threads with scissors. Allows the operator ro concentrate on sewing and thus dramatically increases efficiency. UT with presser foot lifting function raises the presser foot automatically, so the operator can position the next fabric immediately.

Top cover thread trimmer
Cuts the needle, looper and top cover threads. When an operation with top cover thread is perfomed, this trimmer eliminates the need for cutting the top cover thread that otherwise would be a troublesome operation, achieving greater productivity.

Underbed thread trimmer
Cuts the needle and looper threads. After the needle thread is cut, UT with a needle thread wiper picks up the needle thread. Therefore the operator goes to the next operation smoothly.

MS – Condensed stitching device
Thanks to this device, no unraveling occurs because the stitches become automatically finer at the end of sewing. The need for a subsequent anti-unraveling operation is eliminated and quality of sewn products is increased.

AT – Automatic tape cutter
Automatically cuts tape and thread chain for a tape binding or elastic lace attaching operaton. Allows the operator to concentrate on sewing, thereby dramatically increasing efficiency. The knife automatically descends to cut the tape and thread chain as soon as the sensor detects the fabric edge. The remains of tape and thread chain are constant with anu operator because they can be easily adjusted as required by stitch counting.

Driving method	Device type	Subclass
Driving method	Device type	-01	-02	-05	-08
Pneumatic type	AT302	*	*	*	*
Electric type	AT402	*	*	*	*

* mark is available.

TK – Tape cutter
The knife is lowered bu the switch to cut tape and thread chain. Two types of driving methods (pneumatic and electric) are available.

Driving method	Operational method	Device type	Subclass				Remarks
Driving method	Operational method	Device type	01	02	05	08	Remarks
Pneumatic type	Knee switch	TK302	*	*	*	*	?
Pneumatic type	Knee switch	TK303	*	*	*	*	*1
Electric type	Knee switch	TK402	*	*	*	*	?

* mark is available.
*1:Available for 60mm-wide tape

HG – Hemming guide

FT – Fabric trimmer

MD – Metering device

RP – Rear puller

back to main Pegasus page